Hitron ht emn212/3/2023 ![]() It should work, but not to the maximum data rates that you would see with a MoCA 2.0 amplifier. The amp has in integrated MoCA Point of Entry filter and its MoCA 1.0 qualified. ![]() There are cases where techs have installed amps to make up for low signal levels, just want to see if this is one of those cases.Įdit: Just did a quick check. Looking at the modem data, if its connected to that VOIP port will allow us to figure that out. ![]() My concern at this point is whether or not your original signal levels are high enough to support a splitter instead. The copy and paste process will paste in the text contents of the table. Paste that into a post so we can figure out what your original signal levels look like. DOCSIS WAN tab and copy the lower signal level table in its entirety. Typically I believe that the techs will install the internet cable on that port first, and use one of the other ports for the Home Phone, which I also run.Ĭan you have a look at that amp and determine if your modem cable is connected to that port? If so, can you log into the modem, navigate to the STATUS. There will be a 3 dB drop from input to output on that port. That amp has a VOIP port marked on it, which will be a straight thru connection without any amplification. The one question with the amp is whether or not the original signal levels are ok without the amp. I'd give that a go first to see what sort of results you get. ![]() In theory, it can only get better from there. So, you won't get the max MoCA performance out of it, but you might see whether or not its feasible as it is. Only thing to keep in mind is that port to port frequency range maxes out at 1525 Mhz for MoCA 1.0, instead of 1675 Mhz for MoCA 2.0. That amp is MoCA 1.0 qualified, so, as it is, you should be able to run Whole Home plus one MoCA channel in the D-High band.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |